GundamUC

The Steel Legend Metal Build Kshatriya is a third party/bootleg figure. At 1/100 scale it’ll look fantastic with all your MG kits (MG or RE Kshatriya when?!). Who would’ve known that a Metal Build kit out of China would be, not only the best third party piece of Gundam merchandise, but better than any Unicorn official merchandise from Bandai/Banpresto?

 

After a long and frustrating process my MG Sinanju Stein is finally complete.

Saw this build over on figure.fm and wanted to share it with everyone here.
Click to Enlarge

It's his first attempt at a chrome finish and I think it turned out fantastically.

After an initial disaster at my first attempt at pastel weathering, my wounded MG ReZEL has been completed. It didn't turn out like I wanted to. Some people like, some don't. Take a look at decide for yourself. My thoughts on the project at the bottom.
Click to Enlarge | On Flickr

For my damaged ReZEL I decided to give pastel weathering a shot. Everything was going good until I gave it a top coat of Testor's Dull Cote. All of the pastel soaked up into the coat and nearly disappeared.
Click to Enlarge | On Flickr

A one Fat Robot has brought this to my attention. Take a listen to this track off the Gundam Unicorn OST...

At last, I my Full Armor Unicorn is complete. First a few photos you may have already seen...
Click to Enlarge | On Flickr


Click to Enlarge | On Flickr

Built this guy a few weeks ago, finally had sometime to get started on it today. (Mainly because I've all but run out of paint for last pieces of my FA Unicorn) Anyhow, this is a short and simple attempt at a battle worn ReZEL inspired by the Unicorn episode two. While in the ep, the leg is severed at the knee, I thought that would be too easy. So I decided to cut (err, melt) at the thickest part.
Click to Enlarge | On Flickr

It's been a while since I posted any updated shots. This is how the kit looks prior to transformation. Missing a few parts here and there. It will probably never be in this configuration again.
Click to Enlarge | On Flickr


Click to Enlarge | On Flickr

How about an update? Plus another shot of the metallic green!
Click to Enlarge | On Flickr

The legs are finished. A few pieces are over drying still. It's almost ready for a top coat but I'm still debating whether or not to do some decals. But first I need to finish the leg launchers.
Click to Enlarge | On Flickr